V2.00b01	1. Add new PeanutHull DDNS function for new PeanutHull DDNS version.
V2.00b02	1. Fix the issue: Customer uses GPRS modem to dial-up Internet.                           But, customer can't enter init string:                           AT+GDCONT=1,"IP","internet.mts.ru"                            Device can't accept ". 
V2.00b03	Fix Russia issues below:           a. Source port issue(HQ20070117000005)          b. PPTP DNS issue(HQ20070117000005)          c. PPTP and IPSec issue(HQ20061225000007)          d. PPPoE Connective issue(HQ20070115000005)          e. The issue of PPP CHAP CHALLANGE packet on DI-               8xx(HQ20061201000002) 
V2.00b04	Fix the issue below:   1. When adding new rule to QoS and appling and restarting router, the last added rule becomes enabled and others become disabled, and also the router forgets their protocols (TCP:80 becomes *:80). 2. Because DI-804HV\u2019s minimal lifetime is 300 seconds. Therefore, UI will block the setting when users enter the value which is lower than 300 seconds.
V2.00b05	Fix those issues below:  1. DHCP clients can\u2019t get IP address of secondary DNS of the device. 2. Process the IPSEC will initial the session of PPTP if both device located in the same network. 3. PPTP/L2TP connection can\u2019t be establish normally. 4. If users enable both \u201canto-reconnect\u201d and \u201cDDNS\u201d function in VPN function, the device can\u2019t trigger to establish the VPN connection. 
V2.00b07	1. Increase the length of FQDN feature for VPN function to 25 bits. 2. Add IGMP function. 
V2.00b08	Fix the issue: 1. The DI-824VUP+ is configured with Dialup Network and PPPoE with Auto-backup. When DI-824VUP+ goes online over backuped, the UI of connection can\u2019t normally show the Dial-up states. 2. Use VLC-Server for tests. DI-804HV can pass IGMP flow inside LAN. But then we close VLC-client. Flow still exist in LAN ports.   
V2.00b09	When the ISDN backup line is up, if no any traffic from lan side, the ISDN line shall be dropped by idle time out.  
V2.00b10	Fix the issues: 1. Device configured as Dynamic DualAccessPPTP/PPPoE with manual/connect on demand function. When pressing \u201cdisconnect\u201d device close tunnel and Keep address from WAN-PHY. 2. Add the Clone Mac function to the DualAccess PPTP WAN type. 3. Device makes only one try to connect to PPTP server. 4. Device request NTP server every 10 seconds. 5. IGMP Proxy doesn't work with DualAccess PPTP/PPPoE. IGMP request problems doesn't forwards to WAN-PHY and WAN-PPP. 6. Device configured as WAN-StaticIP. Device doesn't forward TCP.RST response from Server if service unavailable. 7. State table doesn't work normally. 8. Add new PeanuHull version. 
V2.00b11	Fix the issue:  Device can't work well with South America's special PPPoE.
V2.00b12	Fix the issue:  1. On page Tools->Time, device is only allowed to choose year 2007(add to 2010).  2. New remote management. 
V2.00b13	Fix the issue:  1. UPnP function can't work(verified by the tool UPnPTest). 2. Can't enable dynamic routing function.