V2.10B10
	Fix the issue
	1.based on V2.10b09
        2.Fix from some other vpn router makes DI-824 reboot when build vpn tunnel.

V2.10b09
        New implementation:
        Base on DI-804HV V1.51b14 and implement the new design for dial-up feature.

V2.10b08
        Fix the issue: 
        1. DI-824VUP can't connect to SmartPhone under WPA-PSK mode.
        2. PPPoE server name can't be saved.

V2.10b02-V2.10b07
        Fix the issue:       
        Add some modifications for GPRS modern issue.
     
V2.10b01
        Fix the issue:   
        1. Renamed from V2.00b15. 2. Remove WAN Type "BigPond". 3. WAN type "Dynamic IP" runs "Auto-reconnect" mode.

V2.00b15
        Fix the issue: 
        1. Fails to run MPPE under PPTP/L2TP server mode.
        2. Can't send mail log under authentication mode.
        3. WAN connection is instable under static IP and Auto-Backup mode. 

V2.00b14
	Fix the issue:
	1. When DI-804HV connects to a PPPoE server(also a DHCP server) under dualAccess PPPoE WAN type, the magic number of the keepalive packets will occur some errors.
	2. DI-804HV can't work normally with DHCP Relay device.
	3. After DI-804HV's PPTP/L2TP server received this rejected packet for "Address/control field compression" from client, it still do this request.

V2.00b13
	Fix the issue:
	1. UPnP function can't work(verified by the tool UPnPTest).
	2. Can't enable dynamic routing function.

V2.00b12
	Fix the issue:
	1. On page Tools->Time, device is only allowed to choose year 2007(add to 2010).
	2. New remote management. 

V2.00b11
	Fix the issue:  Device can't work well with South America's special PPPoE.

V2.00b10
	Fix the issues:
	1. Device configured as Dynamic DualAccessPPTP/PPPoE with manual/connect on demand function. When pressing disconnect device close tunnel and Keep address from WAN-PHY.
	2. Add the Clone Mac function to the DualAccess PPTP WAN type.
	3. Device makes only one try to connect to PPTP server.
	4. Device request NTP server every 10 seconds.
	5. IGMP Proxy doesn't work with DualAccess PPTP/PPPoE. IGMP request problems doesn't forwards to WAN-PHY and WAN-PPP.
	6. Device configured as WAN-StaticIP. Device doesn't forward TCP.RST response from Server if service unavailable.
	7. State table doesn't work normally.
	8. Add new PeanuHull version. 

V2.00b09
	When the ISDN backup line is up, if no any traffic from lan side, the ISDN line shall be dropped by idle time out.

V2.00b08
	Fix the issue:
	1. The DI-824VUP+ is configured with Dialup Network and PPPoE with Auto-backup. When DI-824VUP+ goes online over backuped, the UI of connection cant normally show the Dial-up states.
	2. Use VLC-Server for tests. DI-804HV can pass IGMP flow inside LAN. But then we close VLC-client. Flow still exist in LAN ports.

V2.00b07
	1. Increase the length of FQDN feature for VPN function to 25 bits.
	2. Add IGMP function. 

V2.00b05
	Fix those issues below:
	1. DHCP clients cant get IP address of secondary DNS of the device.
	2. Process the IPSEC will initial the session of PPTP if both device located in the same network.
	3. PPTP/L2TP connection cant be establish normally.
	4. If users enable both anto-reconnect and DDNS function in VPN function, the device cant trigger to establish the VPN connection. 

V2.00b04
	Fix the issue below:
	1. When adding new rule to QoS and appling and restarting router, the last added rule becomes enabled and others become disabled, and also the router forgets their protocols (TCP:80 becomes *:80).
	2. Because DI-804HVs minimal lifetime is 300 seconds. Therefore, UI will block the setting when users enter the value which is lower than 300 seconds.

V2.00b03
	Fix Russia issues below:
	a. Source port issue
	b. PPTP DNS issue
	c. PPTP and IPSec issue
	d. PPPoE Connective issue
	e. The issue of PPP CHAP CHALLANGE packet on DI-8xx

V2.00b02
	1. Fix the issue:
	Customer uses GPRS modem to dial-up Internet.
	But, customer can't enter init string:AT+GDCONT=1,"IP","internet.mts.ru" Device can't accept "."

V2.00b01
	1. Add new PeanutHull DDNS function for new PeanutHull DDNS version.